Bluefin LED Piranha P12 Dual Colour Underwater Boat Light Aluminium Base
Bluefin LED Piranha P12 Dual Colour Underwater Boat Light Aluminium Base
The Piranha P12 Dual-Colour Underwater Light allows you to switch between 3 different blue & white light options. Producing 6,800 fixture lumens, this light will help your boat stand out from the crowd in the marina, river or ocean.
The P12 Dual-Colour has both Cobalt Blue and Diamond White LEDs, and works as follows:
- When first turned on the light will start up in Dual Blue/White mode
- If you turn the light off and on again quickly it will then go to Blue mode.
- If you turn the light off and on again quickly it will go to White mode.
- If you turn the light off and on again quickly it will go to Dual Blue/White Strobe mode.
- When the light is turned off for more than 5 secs it will return to Dual Blue/White mode.
- The light output will adjust itself dependent on the surrounding temperature conditions.
Lights are controlled via a simple on/off toggle switch or via Bluefin’s IYS Control System for MFD/mobile devices. Its ultra-compact, low-profile design is perfect for all types of boats, and is suitable for both transom & side-mounting on all hull types on boats up to 14m (45ft) long.
The P12 Dual-Colour light is also incredibly easy to install with just one small cable-entry hole and 3 mounting screws, and is suitable for a wide range of boats. This model features an aluminium alloy base so it can be installed on a variety of boats (including aluminium boats) without the need for a separating gasket.
For the number of lights your boat needs to pack a colour punch, Bluefin recommends installing 1-5 lights from the Piranha range on the transom or side of centre-console and runabout boats. Recommended spacing between the lights is from 1.2m (3ft 11 inches) to 2m (6ft 6 inches).
This light offers amazing value for money and out-performs other comparably-priced underwater lights.
Features:
- Cobalt Blue & Diamond White LEDs
- Suitable for transom or side-hull mounting
- Surface-mount, requires 15mm cable-entry hole
- Recommended for boats up to 20m (65ft)
- However, the P12 lights have been successfully installed on yachts in the UK as long as 28m (95ft)
- 12 x LEDs, producing 6,800 fixture lumens
- Suitable for in and out-of-water use
- IP68-rated gel connector provided
- Two-year warranty
If hosting a party on your boat isn’t your thing, underwater lights can be great for fishing at night where they not only make it easier to see fish in the water but also attract them to your boat! Different colours penetrate the water to varying depths. Red light can’t be seen past 5m, orange disappears at 10m, yellow at 20m, green (one of the deepest) at 30m, but blue is by far the furthest at 50m.
The human eye is sensitive to blue shades, so this colour stands out and is quite spectacular at night if you are looking for the fishing and party effect. If you usually boat in clear water, white LED lights are stunning at highlighting the beauty of the water.
How your light appears in the water will vary slightly depending on factors such as the mineral content of the water your vessel is in, how deep it is, sea floor & sediment composition, water pollution, water clarity etc.
Note: Not for installation in chlorinated swimming pools - models designed for pools with special seals are available from the supplier. Please contact us for more info.
Mounting Type: : | Surface |
---|---|
Hole cut out size: | 15mm (Gland size: 13mm) |
Maximum Lamp Lumens: | 9000 |
Fixture Lumens: | 6800 |
Max Wattage: | 55 Watts |
Typical Life Expectancy: | 50,000 hours |
Voltage: | Multivolt: 12V/24V |
Power Draw: | 4.6A @ 12V / 2.35A @ 24V |
Protection: | Over / Under Voltage, Over Current, Reverse Polarity protection, Active thermal protection and Hydro block technology |
Fixture Profile: | 17.6mm |
Fixture Diameter: | 110mm |
Lens Type: | 3mm optical-grade high-impact polymer, Guard X Coating |
Fixture Material: | Aluminium |
Beam Angle: | 60 Degree |
Warranty: | 2 Year |
Type Approval: | RINA IEC 60529 |
Available Colours: | Dual Colour Diamond White/Cobalt Blue |
Suitable Use: | Above & below the water-line |
Spacing: | 1.2 - 2.0m |
Driver Type: | Integral |
Total weight: | 500g |
Attached cable length: | 1.8m |
Included in box: | In-line fuse holder & rated fuse, gel connector, inline crimps, heat shrink, fixing screws, template and installation instructions |
Optional Accessories: (sold separately) |
• Junction Box: 4-way IP68-rated Wiring Junction Box • BL-Switch: Panel-mount illuminated switch & wiring loom • 220/110V Power Supply: Power supply 24V for up to 5 lights • I.Y.S Lighting Control: Control via MFD screen or mobile device |
Share
NEED HELP FINDING SOMETHING?
GIVE SAM A CALL TO DISCUSS YOUR REQUIREMENTS - 0449 045 297