Skip to product information
1 of 8

Bluefin LED Piranha P6 NITRO Single Colour Underwater Boat Light Bronze Base

Bluefin LED Piranha P6 NITRO Single Colour Underwater Boat Light Bronze Base

Regular price $681.08 AUD
Regular price Sale price $681.08 AUD
Sale Sold out
Shipping calculated at checkout.

The Piranha P6 Nitro Underwater Light allows you to switch between normal or ‘Nitro’ power, where light brightness is increased by 35%.  Available in either Diamond White or Cobalt Blue & producing 3,600 fixture lumens, this light will help your boat stand out from the crowd in the marina, river or ocean.

How the P6 Nitro Underwater Light works

  • When first turned on the light will start up in Standard Power mode. 
    • If you turn the light off and on again quickly it will then go to Nitro Power mode. 
    • If you turn the light off and on again quickly it will return to Standard Power mode. 
  • When the light is turned off for more than 5 seconds it will return to Standard Power mode.
  • Nitro Power mode increases the lighting power by up to 35%.  The light will remain at this power until it’s temperature hits a certain level, at which point it will dim back to Standard Power mode. The length of time this takes is dependent on the surrounding temperature conditions.
  • As a general guide, the light should be able to stay in Nitro Power mode for around 10 minutes upwards.  This is an approximation however, and depends on the conditions the light is in.

This light is incredibly easy to install with just one small cable-entry hole and 3 mounting screws, and is suitable for a wide range of boats.  For the number of lights your boat needs to pack a colour punch, Bluefin recommends installing 1-5 lights from the Piranha range on the transom or side of centre-console and runabout boats.  Recommended spacing between the lights is from 1.2m (3ft 11 inches) to 2m (6ft 6 inches).  

The Piranha P6 is suitable for all hull types on boats up to 14m (45ft) long.  

Features:

  • Suitable for transom or side-hull mounting 
  • Surface-mount, requires 15mm cable-entry hole
  • Recommended for boats up to 14m (45ft)
  • 6 x LEDs, producing 3,600 fixture lumens
  • Suitable for in and out-of-water use
  • IP68-rated gel connector provided
  • Two-year warranty

If hosting a party on your boat isn’t your thing, underwater lights can be great for fishing at night where they not only make it easier to see fish in the water but also attract them to your boat!  Different colours penetrate the water to varying depths. Red light can’t be seen past 5m, orange disappears at 10m, yellow at 20m, green (one of the deepest) at 30m, but blue is by far the furthest at 50m.  

The human eye is sensitive to both green and blue shades so both colours stand out and are quite spectacular at night if you are looking for the fishing and party effect.   However, if you usually boat in clear water, white LED lights are stunning at highlighting the beauty of the water.      

How your light appears in the water will vary slightly depending on factors such as the mineral content of the water your vessel is in, how deep it is, sea floor & sediment composition, water pollution, water clarity etc.  

Note: Not for installation in chlorinated swimming pools - models designed for pools with special seals are available from the supplier. Please contact us for more info.

Mounting Type: : Surface
Hole cut out size: 15mm (Gland size: 13mm)
Maximum Lamp Lumens: 4500
Fixture Lumens: 3600
Max Wattage: 40W
Typical Life Expectancy: 50,000 hours
Voltage: 12V or 24V
Power Draw: 3.5A @ 12V / 1.8 amps @ 24V
Protection: Over / Under Voltage, Over Current, Reverse Polarity protection,
Active thermal protection and Hydro block technology
Fixture Profile: 17.6mm
Fixture Diameter: 110mm
Lens Type: 3mm optical-grade high-impact polymer, Guard X Coating
Fixture Material: AB2 Bronze (standard)
Beam Angle: 60 Degree
Warranty:  2 Year
Type Approval: RINA IEC 60529
Available Colours: Diamond White 6500k, Cobalt Blue
Suitable Use: Above & below the water-line
Spacing: 1.2 - 2.0m
Driver Type: Integral
Total weight: 500g
Attached cable length: 1.8m
Included in box: In-line fuse holder & rated fuse, Gel connector, Inline Crimps,
Heat shrink, Fixing Screws, Template and installation instructions
Optional Accessories:
(sold separately)
• Junction Box: 4-way IP68 Wiring Junction Box
• BL-Switch: Panel-mount illuminated switch & wiring loom
• I.Y.S Lighting Control: Control via MFD screen or mobile device
View full details